Hotpoint VBXR1060 User Manual download pdf (Page 31)

LP Conversion Instructions

• With the installation of this conversion kit,

the cooktop should operate on LP gas at 10″

of water column pressure.

• The pressure regulator must be connected in series

with the manifold of the cooktop and must remain

in series with the supply line. For proper operation,

the maximum inlet pressure to the regulator must

be no more than 14″ water column pressure for

LP gas.

• When checking the regulator, the inlet pressure

must be at least 1″ greater than the regulator output

setting. If the regulator is set for 10″ of water column

pressure, the inlet pressure must be at least 11.″

IMPORTANT –Disconnect the cooktop and

the individual shut-off valve from the gas supply piping

system during any pressure testing of that system at test

pressures greater than 1/2 psig. Isolate the cooktop from

the gas supply piping system by closing the individual

manual shut-off valve to the cooktop during any pressure

testing of the gas supply piping system at test pressures

equal to or greater than 1/2 psig.

GAS SUPPLY

BEFORE YOU BEGIN, TURN OFF THE GAS SUPPLY AT

THE SHUT-OFF VALVE. DISCONNECT THE ELECTRICAL

SUPPLY FROM THE COOKTOP.

TURN OFF GAS AND

ELECTRIC SUPPLY

CONVERT THE PRESSURE REGULATOR

Locate the pressure regulator under the front

of the cooktop.

Remove the nut from the pressure regulator with

an adjustable wrench.

Twist and remove the conversion plug from the inside

of the nut. Flip the conversion plug over; then insert,

twist and lock it back into place in the nut.

Reinstall the nut onto the regulator.

Apply the LP Conversion label next to the Rating Plate.

Shut-off valve

Electrical supply

Nut

Natural gas

LP gas

Nut

Natural gas LP gas

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Comments to this Manuals

No comments

Hotpoint VBXR1060 User Manual Page 31

Comments to this Manuals

Related products and manuals for Washers Hotpoint VBXR1060