Hotpoint VBXR1060 User Manual download pdf (Page 28)

Installation Instructions

INSTALL THE COOKTOP

ELECTRICAL CONNECTION

Electrical requirements:

120-volt, 60-Hertz, individual, properly grounded

branch circuit protected by a 15-amp circuit

breaker or time-delay fuse.

GROUNDING

IMPORTANT: (Please read carefully.)

FOR PERSONAL SAFETY, THIS APPLIANCE

MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with

a three-prong (grounding) plug which mates with

a standard three-prong grounding wall receptacle

to minimize the possibility of electric shock hazard

from this appliance. The customer should have

the wall receptacle and circuit checked by a

qualified electrician to make sure the receptacle

is properly grounded and has correct polarity.

Where a standard two-prong wall receptacle

is encountered, it is the personal responsibility

and obligation of the customer to have it replaced

with a properly grounded three-prong wall

receptacle in accordance with the National

Electrical Code.

Do Not, Under Any Circumstances,

Cut Or Remove The Third (Ground)

Prong From The Power Cord.

Do not use an extension cord with this appliance.

Plug the power cord into an approved wall outlet.

INSTALL THE COOKTOP

Lower the cooktop into the countertop opening,

guiding it into position.

SECURE THE COOKTOP

Tighten the tie-down bolts to secure the cooktop

to the counter. For countertops less than 1″ thick,

securely attach filler blocks of wood to the bottom

of the countertop where the tie-down bolts will be

tightened.

Countertop

Filler wood block

for countertops

less than 1″ thick

Tie-down

bolt through

cooktop tab

OPTIONAL: ATTACH A BLOWER

TRANSITION DUCT

If using 6″ round standard ductwork, attach

a blower transition duct. This 3

⁄4″ x 10″ rectangle

to 6″ round transition duct is available at your

local building supply store.

Install the transition duct to the blower

outlet. Secure all joints with duct tape

to assure an airtight seal.

Screw

(on other side)

Screws

CONNECT THE DUCTWORK

Connect the ductwork prepared earlier

to the blower transition duct.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Comments to this Manuals

No comments

Hotpoint VBXR1060 User Manual Page 28

Comments to this Manuals

Related products and manuals for Washers Hotpoint VBXR1060