Hotpoint LI2SNA User Manual download pdf (Page 5)

Control panel

Calibrating the control panel

When the plug is inserted (or after a blackout) the

system calibrates the keys; during calibration the

display point flashes. Calibration lasts 15”. The point

stops flashing at the end of calibration.

Off/Stand by: the On condition is obtained by

pressing

for 3 seconds; in this case keys

and

are enabled, the display point and the blue led

of the relative keys light up. The Off condition is

obtained by pressing

again for 3 seconds.

On/Off lights: press to switch on the lights,

which turn amber. Contemporaneously the symbols at

the sides

and turn blue: the intensity of

the light can be increased and diminished with these.

Once the luminosity has been set, pressing

rapidly again memorises it (the symbol turns blue) and

the light

switches off.

Secondary light (only for the models envisaged): press

for a long time to switch it on (at least a second);

press

again for at least a second to switch it off.

On/Off motor: press to switch the motor on.

It turns amber. Contemporaneously the symbols at the

sides

and as well as turn blue.

Press

or to adjust the intensity of

suction. Pressing

again switches the motor off

and the last speed set is memorised.

Intensive timing: by pressing this key the suction

of the hood becomes intensive for a maximum time of 5

minutes. At the end the hood returns to the speed

previously set. To exit from the function earlier press

or one of the following keys: , or

Fats filter signal: this symbol (red led) lights up

after 40 hours. Reset the signal by pressing

for a

long time (at least 3 seconds) until the beep confirms

it.

Carbon filter signal action.

This signal is shown only if it has been previously set.

Proceed as follows: press

with the hood in Off:

first

turns red, after about 1 second also

turns red. If you want to eliminate the carbon filter

signal previously set, press

with the hood in Off.

Reset the carbon filter signal (after 160 hours) by

pressing

for a long time (about 3 seconds, until

the beep).

Description of the appliance

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Hotpoint LI2SNA User Manual Page 5

Comments to this Manuals

Related products and manuals for Cooker hoods Hotpoint LI2SNA