Hotpoint AKM 953/IX Instruction for Use Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 7
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
84
ELECTRICAL CONNECTION
Electrical connection must be made before connecting the
appliance to the electricity supply. The appliance must be
installed by a qualified technician who is fully aware of current
safety and installation regulations. Specifically, installation
must be carried out in compliance with the regulations of the
local electricity supply company. Make sure that the voltage
indicated on the rating plate corresponds to the voltage in your
home. Regulations require that the appliance is earthed: use
conductors (including the earth conductor) of the appropriate
size only. The manufacturer declines all liability for injury to
persons or animals and for damage to property resulting from
failure to observe the above regulations. For the electrical
connection use a HO5 RR-F type cable as indicated in the table
below:
Power supply voltage
.
The appliance must be connected to the electricity supply by
means of an all-pole disconnect switch with minimum
contact gap of 3 mm.
Warning
: the power supply cable must be long enough to allow
the cooktop to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Terminal block connections
Note
: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
Strip approx. 70 mm of the cable sheath from the power
supply cable (
B
).
Strip approx. 10 mm of sheath from the wires. First insert the
cable through the opening in the cover. Then insert the
power supply cable into the cable clamp and connect the
wires to the terminal block as indicated in the diagram
printed on the bottom of the cooktop.
Secure the power supply cable (
B
) by means of the cable
clamp.
Fit and secure the protective cover (
A
) which is screwed to
the lower face of the cooktop.
After the electrical connection, fit the hob from the top and
hook it to the support springs, according to the illustration.
Conductors Amount x size
230 V ~
~
3 X 2.5 mm
2
230 V 3 + ~
~
4 X 1.5 mm
2
400 V 3N + ~
~
5 X 1.5 mm
2
400 V 2N + ~
~
4 X 1.5 mm
2
3gb60832.fm5 Page 84 Thursday, November 15, 2001 12:13 PM
Page view 3
1 2 3 4 5 6 7

Comments to this Manuals

No comments