Hotpoint FIT 801 SC AN HA User's Guide download pdf (Page 7)

LOWER THE TOP HEATING ELEMENT

ONLY IN SOME MODELS

1. Remove the lateral shelf guides.

Pull the heating element out a little and lower it.

3. To reposition the heating element, lift it up,

pulling it slightly towards you, making sure it

comes to rest on the lateral supports.

REMOVING AND REFITTING THE DOOR

1. To remove the door, open it fully and lower the

catches until they are in the unlock position.

Close the door as much as you can.

Take a firm hold of the door with both hands - do not

hold it by the handle.

Simply remove the door by continuing to close it

while pulling it upwards at the same time until it is

released from its seating. Put the door to one side,

resting it on a soft surface.

~15°

3. Refit the door by moving it towards the oven,

aligning the hooks of the hinges with their

seating and securing the upper part onto its

seating.

4. Lower the door and then open it fully. Lower the

catches into their original position: Make sure that

you lower them down completely.

Apply gentle pressure to check that the catches are in

the correct position

(only in some models).

“CLICK”

Try closing the door and check to make sure that

it lines up with the control panel. If it does not,

repeat the steps above: The door could become

damaged if it does not work properly.

1 2 3 4 5 6 7 8

No comments

Hotpoint FIT 801 SC AN HA User's Guide Page 7