Hotpoint AHP69PX User Manual download pdf (Page 10)

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

 The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

 The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

 The accessories can be washed like everyday

crockery, and are even dishwasher safe.

 Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack. For more thorough cleaning purposes, the

oven door may be removed:

1. Open the oven door fully

(see diagram).

2. Lift up and turn the small

levers located on the two

hinges (see diagram).

Glass door

Seal

Lamp

Oven

compartment

3. Grip the door on the two

external sides and close it

approximately half way. Pull

the door towards you, lifting it

out of its slot (see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

recommend that the oven is not used until the seals

have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover using a screwdriver.

2. Unscrew the light bulb and replace it with a

similar one: Wattage 15 W, cap E 14.

Replace the glass cover, making sure the seal is

positioned correctly (see diagram).

Warning:

The appliance is fitted with an automatic diagnostic

system which detects any malfunctions.

Malfunctions are displayed by messages of the

following type: F followed by numbers.

Call for technical assistance should a malfunction

occur.

 Never use the services of an unauthorised

technician.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Hotpoint AHP69PX User Manual Page 10

Comments to this Manuals

Related products and manuals for Microwaves Hotpoint AHP69PX