Hotpoint DSKS333ECWW Installation Manual download pdf (Page 4)

EXHAUST LENGTH CALCULATION

RIGID (Preferred)

3DUWVDUHDYDLODEOHIURP\RXUORFDOVHUYLFHRUJDQL]DWLRQ

:;;µ;·'XFW :;;(OERZ

:;;µ;·'XFW :;;$OXPLQXPKRRG

ALCOVE OR CLOSET INSTALLATION

• If your dryer is approved for installation in an alcove or closet,

it will be stated on a label on the dryer back. The installation

PXVWFRQIRUPWRWKHIROORZLQJVSHFL¿FDWLRQV

WARNING: TO PREVENT LARGE AMOUNTS

OF LINT AND MOISTURE FROM ACCUMULATING AND TO

MAINTAIN DRYER EFFICIENCY, THIS MACHINE MUST BE

EXHAUSTED OUTDOORS.

• Minimum clearances between dryer cabinet and adjacent

ZDOOVRURWKHUVXUIDFHVDUH

0LQLPXP YHUWLFDO VSDFH IURP ÀRRU WR RYHUKHDG FDELQHWV

FHLOLQJHWFLVLQ

• Closet doors must be louvered or otherwise ventilated and must

FRQWDLQDWOHDVWVTXDUHLQFKHVRIRSHQDUHDHTXDOO\GLVWULEXWHG,I

the closet contains both a washer and a dryer, doors must contain

at least 120 square inches of open area equally distributed.

NOTE TO INSTALLER - AFTER INSTALLATION CHECK

THE FOLLOWING:

(;+$867'8&70XVWPHHWVSHFVRQSDJH1RH[FHVVLYH

WXUQV1RNLQNVRUREVWUXFWLRQVWRDLUÀRZ

(;+$867+22'6KRXOGZRUNIUHHO\DQGRSHQGRZQZDUG

*5281',1*'U\HUPXVWEHSURSHUO\JURXQGHGWRFRQIRUPWR

local codes and ordinance requirements.

23(5$7,217XUQGU\HURQDQGFKHFNIRUKHDW

+$1'&86720(57+(2:1(5·60$18$/*LYHLQVWUXFWLRQVRQ

RSHUDWLQJWKHGU\HU$QVZHUDQ\TXHVWLRQV

*,9(7+(6(,167$//$7,21,16758&7,216WRWKHFXVWRPHU

4" DIA.

2-1/2"

RECOMMENDED MAXIMUM LENGTH

Exhaust Hood Types

Recommended

No. of 90°

Elbows

Rigid

Metal

Rigid

Metal

14 m (46 ft)

11 m (37 ft)

9 m (30 ft)

7 m (23 ft)

11 m (37 ft)

9 m (30 ft)

6.5 m (22 ft)

4.5 m (15 ft)

Use only for short

run installations

CONNECTING THE DRYER TO HOUSE VENT

RIGID METAL TRANSITION DUCT

• For best drying performance, a rigid metal transition duct is

recommended.

• Rigid metal transition ducts reduce the risk of crushing and

kinking.

UL-LISTED FLEXIBLE METAL (SEMI-RIGID) TRANSITION DUCT

,IULJLGPHWDOGXFWFDQQRWEHXVHGWKHQ8/OLVWHGÀH[LEOHPHW

DOVHPLULJLGGXFWLQJFDQEHXVHG.LW:;;

 1HYHU LQVWDOO ÀH[LEOH PHWDO GXFW LQ ZDOOV FHLOLQJV ÀRRUV RU

other enclosed spaces.

7RWDOOHQJWKRIÀH[LEOHPHWDOGXFWVKRXOGQRWH[FHHGIHHW

P

• For many applications, installing elbows at both the dryer

DQGWKHZDOOLVKLJKO\UHFRPPHQGHGVHHLOOXVWUDWLRQVEHORZ

Elbows allow the dryer to sit close to the wall without kinking

and or crushing the transition duct, maximizing drying

performance.

• Avoid resting the duct on sharp objects.

UL-LISTED FLEXIBLE METAL (FOIL-TYPE) TRANSITION DUCT

• In special installations, it may be necessary to connect the

GU\HUWRWKHKRXVHYHQWXVLQJDÀH[LEOHPHWDOIRLOW\SHGXFW

$ 8/OLVWHG ÀH[LEOH PHWDO IRLOW\SH GXFW PD\ EH XVHG 21/<

LQLQVWDOODWLRQVZKHUHULJLGPHWDORUÀH[LEOHPHWDOVHPLULJLG

ducting cannot be used AND where a 4” diameter can be

maintained throughout the entire length of the transition duct.

,Q&DQDGDDQGWKH8QLWHG6WDWHVRQO\WKHÀH[LEOHPHWDOIRLO

W\SH GXFWV WKDW FRPSO\ ZLWKWKH´2XWOLQHIRU &ORWKHV 'U\HU

7UDQVLWLRQ'XFW6XEMHFW$µVKDOOEHXVHG

 1HYHU LQVWDOO ÀH[LEOH PHWDO GXFW LQ ZDOOV FHLOLQJV ÀRRUV RU

other enclosed spaces.

7RWDOOHQJWKRIÀH[LEOHPHWDOGXFWVKRXOGQRWH[FHHGIHHW

P

• Avoid resting the duct on sharp objects.

For best drying performance

1 Slide one end of the duct over the clothes dryer outlet pipe.

2. Secure the duct with a clamp.

:LWKWKHGU\HULQLWVSHUPDQHQWSRVLWLRQH[WHQGWKHGXFWWR

its full length. Allow 2” of duct to overlap the exhaust pipe.

&XWRȺDQGUHPRYHH[FHVVGXFW.HHSWKHGXFWDVVWUDLJKWDV

SRVVLEOHIRUPD[LPXPDLUÀRZ

4. Secure the duct to the exhaust pipe with the other clamp.

NOTE: The clearances stated above are minimums.

Consideration must be given to the type accessory kit

XVHGZLWKGU\HU5HIHUWRWKHVSHFL¿FNLWLQVWUXFWLRQIRU

details.

Alcove Closet

Sides 0” 1”

Top 1” 1”

Front µ

Rear µ µ

WHEN INSTALLED IN MANUFACTURED (MOBILE) HOMES

Dryer must be exhausted to the outside. Exhaust MUST NOT be

terminated beneath mobile home. Exhaust material MUST NOT

support combustion. Installation MUST conform to Manufactured

+RPH&RQVWUXFWLRQ6DIHW\6WDQGDUG7LWOH&)53DUW

or when such standard is not applicable, the American National

6WDQGDUGRI0RELOH+RPHV$16,1)5$1R%)RUHOHFWULFDO

connection, see “Connecting dryer using 4 wire connection”.

USE OF CASTERS (120V PORTABLE MODELS ONLY)

For a portable installation screw casters into the holes on the bottom of the

dryer. Refer to the “Installation Instructions for caster assembly” sheet to

install casters.

• )RUHYHU\H[WUDHOERZUHGXFHWKHDOORZDEOHYHQWV\VWHPOHQJWK

by 10 ft.

• 7ZRHOERZVZLOOEHWUHDWHGOLNHRQHHOERZ

• )RUWKHVLGHH[KDXVWLQVWDOODWLRQVDGGRQHHOERZWRWKHFKDUW

• The total vent system length includes all the straight portions and

HOERZVRIWKHV\VWHPWUDQVLWLRQGXFWLQFOXGHG

FLEXIBLE

7RWDO OHQJWK RI ÀH[LEOH PHWDO GXFW VKDOO QRW H[FHHG  IW  P 7KH

IROORZLQJNLWLVDYDLODEOHIURP\RXORFDOVHUYLFHRUJDQL]DWLRQ

.LW:;;µGLDÀH[LEOHPHWDOVHPLULJLG8/OLVWHGWUDQVLWLRQ

GXFWLQFOXGHVHOERZV

1 2 3 4

Comments to this Manuals

No comments

Hotpoint DSKS333ECWW Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Electric laundry dryers Hotpoint DSKS333ECWW