Hotpoint TFA34 User Manual download pdf (Page 15)

The Controls

Heat Switch (OUT low heat, IN high heat) Fresh Air Switch (OUT normal IN Fresh Air)

Drying Guide Timer

Fresh Air

Light

Drying Light

Timer control

Heat Selection

Fresh Air Selection

Drying Light

Fresh Air Light

The Cool Tumble/

Fresh Air phase

The Fresh Air /

Cool Tumble phase

Turn the timer clockwise to select the required drying time.The timer

controls the drying time for both heat settings.

Never wind the timer control anti-clockwise.

Turning the timer also starts the dryer, provided the door is closed and the

machine is plugged in. The “Guide To Drying Times” section will tell you

how much time you’ll need for various loads.

The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat.

The choice of HIGH HEAT or LOW HEAT depends upon the fabric you wish

to dry (see section, ‘Sorting your Laundry’)

The button is ‘OUT’ for normal drying and ‘IN’ for ‘Fresh Air’ drying.

If selected, outside air will be drawn into the machine and gently blown

through the drying load.

This light glows during any drying programme and goes out at the start of

the ‘Cool Tumble/Fresh Air’ phase.

This light glows during any drying programme when the Fresh Air option

is selected.

About 20 minutes before the programme is completed, the heating

elements will be switched off, and the programme enters the final ‘Cool

Tumble/Fresh Air’ phase. For the dryer to switch into fresh air mode, it

must be pre-selected (button pressed) before the drying cycle begins.

During this phase, the fabric is cooled. You should always allow the dryer

to complete this phase.

To give your laundry a quick refresh simply select Fresh Air (press the

button), then turn the timer to the fresh air symbol .

Provided the door is closed and the power is on the machine will start.

To refresh without Fresh Air simply turn the timer to the cool tumble

symbol .

Each of these programmes will take approximately 20 minutes.

We recommend that the clothes are removed immediately after the

programme has finished to minimise creasing.

NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE DRUM.

YOU MUST TERMINATE EVERY PROGRAMME WITH THE COOL TUMBLE

OR FRESH AIR PHASE.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Hotpoint TFA34 User Manual Page 15

Comments to this Manuals

Related products and manuals for Dryers Hotpoint TFA34