Hotpoint FDD 912 User Manual download pdf (Page 3)

The dishwasher meets the requirements set out

by the regulations in force concerning safety and

electrical equipment.

Any technical checks should be conducted

exclusively by a trained and authorised technician:

Repairs carried out by unaithorised persons will

invalidate the guarantee, as well as posing a

potential hazard to the user.

The manufacturer declines all responsibility for

damage to persons or property resulting from failure

to observe the above precautions, from tampering

with even a single component or from the use of

non-original spare parts.

Electrical Connection

Before inserting the plug into the electrical socket,

make sure that:

 the socket is earthed and complies with current

regulations;

 the socket can withstand the maximum load of

the appliance, which is indicated on the data

plate located on the inside of the door (see

Description of the appliance);

 the power supply voltage falls within the values

indicated on the data plate on the inside of the

door;

 the socket is compatible with the plug of the

appliance. If this is not the case, ask an

authorised technician to replace the plug (see

Assistance); do not use extension cables or

multiple sockets.

Once the appliance has been installed, the

power supply cable and the electrical socket should

be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must

be replaced by the manufacturer or its Technical

Assistance Service in order to prevent all potential

hazards. (See Assistance)

This appliance must be earthed.

Fuses:your appliance comes fitted with a plug and a

13A fuse. If you need to replace the fuse, only those

rated at 13A and ASTA approved to BS1362 should

be used. If you lose the fuse cover, a replacement

may be obtained from your local authorised Service

Centre or Electrical company. Correct replacement is

identified by colour coding or the marking on base

of plug.

DO NOT use the plug unless the fuse cover is

fitted.

Changing the Plug

Cut off and dispose of the supplied plug if it

does not fit your socket.

To avoid a shock hazard DO NOT insert the

discarded plug into a socket anywhere else.

Wires in the mains lead are coloured accordance

with the following code:

Green/Yellow - Earth

Blue - Neutral

Brown - Live

If you change the plug, the colour of the wires in the

mains lead may not correspond with the terminal

markings in the plug, which if not coloured, could

be:

EARTH E or

NEUTRAL N

LIVE L

Changing the Mains Lead

A lead can be ordered from Hotpoint Service

UK: 08709 066 066 or

Republic of Ireland: 1850 302 220

- If you have damaged the existing lead or require a

longer one a charge will be made. It is strongly

advised that this work is carried out by a qualified

electrician.

- If the domestic wiring includes a residual current-

operated circuit breaker, ensure that it conforms to

the latest regulations.

The dishwasher must not be connected to the

electricity supply while installation is being carried

out.

- This appliance should only be connected to a 230/

240V AC source, via a properly installed earthed

socket.

- Use the dishwasher solely in a domestic

environment.

- DO NOT stand or place heavy objects on the door

when it is open, this could damage the door or

cause the appliance to tip forward.

The Company shall not be held responsible for

any incidents that occur if these regulations are not

observed.

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Hotpoint FDD 912 User Manual Page 3

Comments to this Manuals

Related products and manuals for Dishwashers Hotpoint FDD 912