Hotpoint HAG60P Operations Instructions download pdf (Page 5)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Installation

Prior to installation, ensure that the local distribution

conditions (nature of the gas and gas pressure)

and the adjustment conditions are compatible. The

adjustment conditions for this appliance are stated on

the data badge which is fitted on the back panel.

This appliance is not designed to be connected to a

combustion products evacuation device. It must be

installed and connected in accordance with current

installation regulations. particular attention should

be given to the relevant requirements regarding

ventilation.

MODEL NUMBERS HAG 60

Category II2H3+ (GB)

These models are set to burn NATURAL GAS (G20)

at 20 mbar but can be converted for use on BUTANE

(G30) at 28-30mbar with the use of the LPG conversion

kit that can be obtained free of charge, if you contact

our Genuine Parts and Accessories department (see

Key Contacts, back page).

GAS SAFETY (INSTALLATION & USE)

REGULATIONS

It is the law that all gas appliances are installed by

competent persons in accordance with the current

edition of the above regulations. It is in your interest

and that of safety to ensure compliance with the

law. In the UK, CORGI registered installers work to

safe standards of practice. The cooker must also be

installed in accordance with BS 6172. Failure to install

the cooker correctly could invalidate the warranty

liability claims and could lead to prosecution.

Adapting to different types of gas

(main and top oven)

In order to adapt the oven to a different type of gas

with respect to the gas for which it was manufactured

(indicated on the label), follow these simple steps:

a) Replacing the oven burner nozzle

 open the oven door fully

 pull out the sliding oven bottom

 Pry the fixing tab "V" and remove the oven burner

 Unscrew the oven burner nozzle using the socket

spanner for the nozzles "Z", or a 7 mm socket

spanner, and replace it with a nozzle suited to the

new type of gas (see Table). Take particular care

handling the spark plug wires and the thermocou-

ple pipes.

 Replace all the parts, following the steps described

above in the reverse order.

G20 at 20mbar

G30 at 28-30mbar

G31 at 37mbar

Burner

Heat Input Injector Heat Input Injector

Hotplate

Front Left and Rear Right

3.0 kW 116 3.0 kW (220g/h) 86

Hotplate

Front Right and Rear Left

2.0 kW 103 2.0 kW (145g/h) 70

Grill 3.7 kW 150 (X) 3.4 kW (246g/h) 91

Main Oven 2.5 kW 115 2.3 kW (166g/h) 71

Top Oven 1.9 kW 100 1.9 kW (136g/h) 66

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Hotpoint HAG60P Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for Cookers Hotpoint HAG60P